Terrible first layer - 3D Printing / 3D Printers - Talk

Hello, I recently bought a Printrbot Play, and I’m experiencing some problems with my first layer. The first layer looks acceptable for small objects, but when I print some bigger objects (with a greater surface) it just looks terrible. As you can see on the picture, it looks like the infill is way to big to fit inside the perimeters of the first layer. It is actually crossing the bottom perimeter, and causing the layer to “wave”. The small square on the left has this issue also, but less

prusa i3 - First layer looks weird and print fails - 3D Printing Stack Exchange

🔥 The definitive guide to solving 3D printing problems by Bitfab - Bitfab

CPE / PETG terrible first layer & surface quality - Materials & profiles - UltiMaker Community of 3D Printing Experts

3D Printering: Is Hassle-Free Bed Leveling Finally Here?

Why does a 0.10 first layer thickness look significantly higher than a 0.15 first layer thickness? Details in comments. : r/FixMyPrint

pla - First layer prints too thin causing gaps everywhere - 3D Printing Stack Exchange

Getting a smooth bottom layer of PLA - Improve your 3D prints - UltiMaker Community of 3D Printing Experts

extrusion - First 3 mm prints poorly, then fine after that - 3D Printing Stack Exchange

Terrible first layer - 3D Printing / 3D Printers - Talk Manufacturing

What changed? Not the smooth first layer it used to be, same file I've printed 50 times. P1P. : r/BambuLab

Bad First Layer – How do I print this? (Printing help) – Prusa3D Forum

First layers bubbles issue - LulzBot Mini - LulzBot